Skip to main content

Specifications For Slotted Heavy Duty Tension Pins

Metric Series-ISO 8752 (formerly DIN 1481)

tension pins single chamfer

Metric Pins 8MM and smaller diameter double chamfer is standard (see top chart)

Metric Pins over 8MM in diameter single chamfer is standard (see bottom chart)

Nominal Diameter *
11.522.533.544.5568
a Max0.350.450.550.60.70.80.8511.11.42
a Min0.150.250.350.40.50.60.650.80.091.21.6
d1 Max1.31.82.42.93.544.65.15.66.78.8
d1 Min1.021.72.32.83.33.84.44.95.46.48.5
d2 ~0.81.11.51.82.12.32.82.93.445.5
s0.20.30.40.50.60.750.8111.21.5
Minimum lift-off load**
Double shear KN
0.71.582.824.386.329.0611.2415.3617.5426.0442.76
LengthLength tolerance           
4            
5            
6+/- 0.25           
8            
10            
12            
14            
16            
18            
20            
22            
24            
26+/- .05           
28            
30            
32            
36            
40            
45            
50            
55            
60            
65            
70            
75            
80+/ - 0.75           
85            
90            
95            
100            
120            
140            
160            
180            
200            

* The spring pin's nominal diameter equates to the normal diameter of the respective location hole, whose tolerance zone is to ISO H 12
** In individual cases, it is important to check whether these shear forces can be taken into account depending on the structural properties.
Other diameters not shown can be manufactured

Nominal Diameter *
1012131416182021252830323538404550
a Max2.42.42.42.42.42.43.43.43.43.43.43.63.64.64.64.64.6
a Min22222233333334444
d1 Max10.812.813.814.816.818.920.921.925.928.930.932.935.938.940.945.950.9
d1 Min10.512.513.514.516.518.520.521.525.528.530.532.535.538.540.545.550.5
d2 ~6.57.58.58.510.511.512.513.515.517.518.520.521.523.525.528.531.5
s22.52.5333.54455.56677.57.58.59.5
Minimum lift-off load**
Duble shear KN
70.16104.1115.1144.7171222.5280.6298.2438.5542.6631.46848591003106813601685
LengthLength tolerance                 
4                  
5                  
6+/- 0.25                 
8                  
10                  
12                  
14                  
16                  
18                  
20                  
22                  
24                  
26+/- .05                 
28                  
30                  
32                  
36                  
40                  
45                  
50                  
55                  
60                  
65                  
70                  
75                  
80+/ - 0.75                 
85                  
90                  
95                  
100                  
120                  
140                  
160                  
180                  
200                  

* The spring pin's nominal diameter equates to the normal diameter of the respective location hole, whose tolerance zone is to ISO H 12
** In individual cases, it is important to check whether these shear forces can be taken into account depending on the structural properties.
Other diameters not shown can be manufactured